Centrix SA1DK Manual de Instruções descarregar pdf (Página 14)

26 27

Return To Factory Default Settings

Replacing a lost Programming Code

Warning:

You must be very careful before using this command! Doing so will erase the entire memory

which includes all User and Special Codes, and return all codes to their factory default

settings.

1)EnterProgrammingMode

2)Press“0”toenterMenu 0

 •TheModeLEDwillashred

 •TheDoorLEDwillashred

3)Enterthe4-digitProgrammingCode.

 •IftheProgrammingCodeisvalid,allmemorywillbeerased,youwillhear3beepsand

 thecontrollerwillreturntoNormalMode

 •IftheProgrammingCodeisinvalidyouwillhearalongbeepandthecontrollerwill

 returntoNormalModewithouterasingthememoryofthecontroller.

Note : TheSA1DKmustbeinNormalModeotherwisethiswillnotwork.MakesurethattheMode

LEDisgreenbeforeproceeding.

1)RemovepowerfromtheSA1DK

2)PresstheREXbutton

3)ApplypowertotheunitwithREXbuttonpressed

4)ReleasetheREXbutton

5)Younowhave15secondstoprogramanewProgrammingCodeintotheunitusingtheinitial

defaultcode1234,beforethecontrollerrevertstotheexistingcode.

Replacing a lost Programming Code

Note : TheSA1DKmustbeinSecureModeotherwisethiswillnotwork.MakesurethattheMode

LEDisredbeforeproceeding.

1)RemovepowerfromtheSA1DK

2)PresstheREXbutton

3)ApplypowertotheunitwithREXbuttonpressed

4)ReleasetheREXbutton

5)Younowhave15secondstoprogramanewNormal/SecureCodeintotheunitusingtheinitial

defaultcode3838,beforethecontrollerrevertstotheexistingcode.

1 2 ... 9 10 11 12 13 14 15 16

Sem comentários

Centrix SA1DK Manual de Instruções Página 14